This canopy is for the fullspeed leader 120
I designed this canopy to accommodate the runcam micro Swift 2 fpv camera.
The goal here was to keep the leader look but also provide proper fit and camera protection for the Runcam.
To put this together you will need to First rem out the side plates to allow the bolt to pass through. (#31 drill or .125 drill)(the side plate screws that come with the leader will not fit) You will need to get 6 M3x8 or M3x6 screws this can be either nylon or Steel, if you do choose to go with nylon I would run a steel screw in there to help put threads in the plastic, or if you have a 3m x .05 tap, first drill out with a #40 drill before tapping
depending on your printer the holes should be pretty close to the right size
This is bolted to the frame using the original 2 screws that came with the leader
After getting the canopy bolted together I put it on the frame and used a 1/16 drill bit to drill the hole for the screw to go in.
Please post your "I made one" wanna see how yours turned out !
Enjoy and as always Happy Flying!!
If you would like one printed out, Hit me up!
02/08/2018 added version2 of the side plates, stronger where I think it needed it.
02/09/2018 added a xanuser_version changed the top hole to 2m and added a bit around the cam mount, this is meant to use the side plates only and use 2m standoffs
02/09/2018 The_tungsten2k_version is a one piece print that includes the side pieces in the centerpieces in one print you must use supports when printing this,I am fixing to prepare printed I will update the results when Im done along with photos
This this was printed in the makerGeeks abs and has gone through a acetone Vapor chamber treatment.
Support probably don't need to be used on the top but I did anyway just out of caution