Me and my Colleges were impressed by Chaos Cor Techs Bus, so i made some.
I figured out, that it would be nice to light it up instead painting it.
So i designed this diffusor to spread the light of an LED light strip.
You will need a "mini RGB LED controller" and add a RGB Strip to it.
You also need to drill a hole on the bottom of the bus to get the power supply cable through.
I hope you enjoy it.
The Diffusor can be used without cap, but turned upside down aswell (this results in better diffused light, but is also a bit less bright)
All snug fit but removable for maintenance.
Wall Thicknes should be 2 perimeter with tranparent PLA.
2 Bottom Layer are recommended.
If the glue of the LED stripe is not strong enough, i designed the bottom plate to fit some cable ties to do this job.