These are 1:200 models of a Tiger II. Models of both Porsche and Henschel turrets are provided. These models have a snap in turret; after clean up just SLOWLY snap the turret in, no fitting is required.
These are based on m_bergman's excellent model of a Tiger II. The snap joint was derived from the clone trooper model.
Designed to print on the M3D Pro, but it should print fine on the micro.
For a better looking model, print as shown. If you want a quick clean up of the turret, print it with the barrel pointing up. Make sure supports are only set from the print bed to the model. Model on model support and printing the hull perpendicular to the print bed may mess up the snap in joint. Be sure to clean out between the snaps on the turret. This model works well with ABSr grey.
On the M3D Pro, 50 micron steps can make a single good model with ABSr grey, but 100 micron is the best for making batches with the stock filament setting. The sample image shows models printed with 100 micron layers.