Shelf mount for the TPCast TX transmitter. Allows mounting the transmitter to a shelf without sticky tape or screws. The angle of the transmitter can be adjusted and the spare usb has a place to stop it from dangling around.
To use the clamp also for the Vive lighthouses the spacing of the screw holes also fits the included wall mounts.
Just the arm needs support material to print. The other parts don't need support.
Don't change the orientation of the parts for maximum strength. This especially is true for the top piece because otherwise it will snap in assembly. Depending on your printer the bottom pieces may need a bid of sanding to fit together. It should be a good friction fit.
Requires 2x M3x16 screws and nuts and 1x tripod screw.
Clamp spacing is fits the standard 20mm Ikea shelfes.
If you print one please share a "I made one" ;)
Just the arm needs support material in some one place.