Save your half spent caulking tubes with this handy little plug shaped like a rocket. Modeled after some overpriced existing products in this arena, this is a simple print. No promises on how many years you can store your caulking for with this plug, but atleast its better than a nail with duct tape wrapped around it.
As with all my designs, I have included the Fusion360 file so you can see how I made it or make your own tweaks.
Check out my other designs for other cool stuff for around the garage.........
Printed with Zyltech PLA at 210C with glass bed at 60C. Printed with rocket pointed upward. Used small raft to ensure decent bed contact. Printed in about 15 min each. I recommend printing 2 or more at a time to allow the tips to cool as the printing reaches the top.
Sliced in Cura. 0.2mm layer with 1mm wall. Could go thinner and use infill but it didn't save time or much material so I kept it at 100%.