Loading
SamHain07

CR-10S Locking Bed Leveling Knob

by SamHain07 Dec 19, 2017
Download All Files

Thing Apps Enabled

Please Login to Comment

I printed these and when I installed them, the lock nuts under the bed that keep the screw from turning also kept the spring from resting against the under side of the bed and took up too much space. Even if I had the knobs tightened all the way and the springs completely compressed, the bed was still to high to allow me to level it. You wouldn't think the height of an M4 lock nut could make that much difference, but it did. I think I may have solved this issue by purchasing 4 new compression springs (Menards - Part #88015). They are bigger in diameter, going over the nuts and resting against the bed. They are also longer but a little weaker than the OEMs so I'm hoping they will be close to the same in the end. Time will tell if they will hold. I have now leveled the bed with the new knobs and springs and they all seem to work great. These knobs are a vast improvement over the tiny knobs it had. I am using a Creality CR10S. Thanks