Before you print!
I recommend PLA for this print.
Requirements: Acrylic sheets, 32(you can use less) M3 screws longer that 1cm with nuts.
1 - Once printed position the parts as in the image.
2 - Cut out and from any material a bottom plate and attach it (this is important - it will hold all the parts together)
3 - Place the power supply in its position
4 - Place the mother board in its place and wire it up
5 - You can start attaching the side plates
6 - attach the screen to the motherboard and place it in the screen holder on the frame.
7 - Take notes on any modifications you would do and post them here :)
The SKP files are available for download!
Thank You very much for choosing this case for your printer :)