by gluetolf Jul 23, 2012
Download All Files

Thing Apps Enabled

Please Login to Comment

This model Looks very detailed and nice, but i cannot print in on our ultimaker 2

Has anyone printed this on a Ultimaker 2? If so, which settings did you use? The Cura (Version 14.09) slicer engine only finishes on verly low Detail Settings, and else aborts with an "unknown error"... any suggestions?

Hi, I have no problem slicing the model using 0.08mm layer settings. Do you slice it standing or laying flat?

Hi, I slice it laying flat as it is shown in the picture above. It is ok to about 5cm across, but if I try to make it larger, the error occures. Which program do you use to slice it?

Did you try the latest version of cura 14.12.1?