Loading
Palmiga

Christmas Tree Spiral Bauble with Xmas Trees & Snowmen

by Palmiga Dec 22, 2017
Download All Files

Thing Apps Enabled

Please Login to Comment

Had problems printing first time, then analised the model and to my surprise it is two layers with an air gap. Is this correct and if so please would you advise best method of printing this design. Also should it printed with magnification before slicing? Is its model size a bit small to print?

Advice would be appreciated.

Yes correct. It was designed for SLS printing. U need to use support if printed with FDM/FFF printer but it might be a challenge still due to small details. Good luck and would love to see if you are successful:)

Decided to check out a fully supported model and got to slicing and it said it would take 2 days at 0.15 pitch and 1.5 magnification. Gave up on that one. Then tried cutting model in half and printing top half. Got messy and at the moment I have given up. Cann't afford a SLS printer for just this model. Christmas will have to miss out on this delight :) May take this on as a challenge at some future time, maybe!
Thanks for the additional information and reply