Woman - https://www.thingiverse.com/thing:1384034
Stump - https://www.thingiverse.com/thing:2322353
Tree - https://www.thingiverse.com/thing:1610041
I had this idea to create a Youthful and Attractive Mother Earth figure inside of a Voronoi Sphere with the 7 Continents of the Earth on the outside of the sphere. Sphere is approximately 100mm in diameter. Well after many failed attempts of trying to develop model of just the continents, I gave up. Maybe someone smarter than me can make that happen. also the bottom of the object is not perfectly flat so a Raft will be required to get the lower edges of the sphere to stay held down. And honestly a few of the upper limbs could be moved to improve support printing the top overhangs of the Voronoi sphere. There is also one small droop of filament under here chin which i didn't see during modeling that would be nice to get fixed.
For my lack of knowledge modeling organic shapes, I'm very pleased with the result.
Printer: XYZ Da Vinci Mini
3D Modeler: AutoDesk Meshmixer
3D Slicer: XYZware
Filament: ~15 meters of 1.75mm PLA
Run Time: ~7.5 Hours