Print with laying flat (my fusion stls always come out 90° turned around X-axis)
I print them with the Cura settings:
- Wall line count = 3
- Top/bottom count = 3
Three brim lines to support the narrow hooks.
Support at 5%, ZigZag pattern, touching build plate only (probably not used in the model)
- 0.3mm height at 200% line width
- Remaining layers:
- 0.2mm height, 0.4mm width (=nozzle diameter)
- 60mm/s print speed, except:
- outer walls: 30mm/s
Clip the helpers from the tiny hooks at the rail ends. Cut and/or sand the brim lines away. Enjoy.