Model is 250mm high, though it should increase ok if needed but I haven't check any of the tolerances.
I spit https://www.thingiverse.com/thing:2054299 light saber down to make a stand for a Kylo Ren mask that I have printed.
I have designed a base for this print to sit on using a strong magnet at the base of the light saber.
The bottom section should be printed upside down to lessen the amount of support needed.
The middle section should be printed up right with plenty of support to keep the detail of the handle.
The top section can be printed upright but will need support for the arms.
The split down top is to save time and support for the arms. The arms have been added separately and they are sided.
I have not printed the split down version and I am unaware what the fitment is like, though it look good in tinkercad.
Thanks to https://www.thingiverse.com/Grandaltoclaripipebone for letting me remix this.