150mm Leg extension for IKEA Lack coffee table. This will fit all IKEA lack tables.
Printed using PolyMaker PolyPlus PLA
Bed Temp 60
Flow Rate 97%
I recommend printing with a brim. It gave me the best results. It isn't required, however.
I tried dropping the infill to 20%, but the result wasn't strong enough. With the above settings these extensions were rock solid. I added the "feet" because the coffee table is wide and, given the things I will be putting on it, (the CR-10 S4, loads of filament, a display, and the inevitable pile of misc tools that will end up there) would wobble just a bit when raised ― enough to make me uneasy. So, with the "feet" added and braced it works like a champ.
There are countersunk screw holes, but it goes down deep enough that once the extensions are on that it takes a good bit of tugging to get them back off. So, I didn't feel the need to use them. With that in mind, make sure you've got the feet pointed in the direction you want them.