This is an Enclosure for the MKS Gen L V1.0 control board and the RepRapDiscount Full Graphic Smart Controller supplied with the P905X Flyingbear Printer.
On the P905X It required me to extend all of the wires, except for the stepper motor wires, to connect to the enclosure. Please use the proper gauge wire to do this.
The pictures illustrate how I ran the wires and cable tied the display cables to fit.
Once 6 pieces are printed, Super glue Bottom to Left and Right sides. Then Super Glue the fan top plate to the back plate. See pictures.
(4) #4 x 3/4" lg wood screws to attach the display to case.
(3) #4 x 3/8" lg wood screws to attach the fan top plate / back to the case.
(4) #4 x 3/8" lg wood screws (TRIMMED TO 1/4" OR LESS) to attach control board to case.
Fan mounting used supplied kit hardware for original fan mounting and (4) 3 mm flat washers to space between the fan and top plate