I struggled to find a mount that worked for how I wanted the antenna to mount. I went through 13 different versions of mounting the antenna because I wanted to have it come out the back. Plus I wanted the antenna to be far enough away from the battery to get good signal. I have not liked any of them. I am ok with the final one. I would have save myself a lot of time if I had just used the antenna mount that Kabab designed into the frame.
I have a TBS Unify SMA Pigtail that I cut the tabs off the end to save some weight so I could get the square that is on the back of the mount.
The final one I landed on was 20deg tilt printed out of pla. There are 4 different mounts in the skp file attached. 7.5deg, 15deg, 20deg, 25deg
The quad build is at rotobuilds
Only did support on the items above the build plate.