Why I've remixed it
Because I've got a large bed, and I was loosing 3cm of printable zone.
The blTouch was not able to probe entirely the bed.
Also, I was lazy to buy extra screws...
And the belt tensioner is less high than the original, allowing a lower bed.
What you need
Nothing, except 2 M4x40 screws and nuts.
Normally you've got extra M4x34 nuts with the tarantula kit.
So do the change with M4x40 screws of idlers.
Also you save 2 M4 T-nuts. ( Enjoy )
How to install
There is only 3 parts. Go ahead on your own !
If you have some issue or question, tell me in the comment section.
Please put some photos if you've made it. :)
Tevo Tarantula (Prusa i3 clone)
No support, no brim, no raft.