Loading
SeanStJames

Raspberry Pi Camera Mount for CR-10

by SeanStJames Jan 11, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

hi, how long should the m5 bolts be as i need to order some?

Comments deleted.

Very handy, thanks. The only problem I had was that the axis change connector has tricky overhangs whichever way you print it (perhaps inevitably). Still, it's screwed together and watching my prints perfectly!

Is this for the Raspicam V1 or V2?

Since the mount is on the front, all you should need is the V2 back from here https://www.thingiverse.com/thing:2307685
After printing, I needed to cut about 1/3rd of the inside wall thickness from each side of the back, for about 1/8", at the very end where the camera connector is. The connector opening tabs on mine were a bit wider than the connector itself and needed more clearance.. Alternatively, you could cut those tabs on the camera connector down just a little and not modify the back..
This is assuming the case is from this original source https://www.thingiverse.com/thing:92208 or a derivative, but it looks like it just looking at the back in these files.

Case backplate for Raspberry Pi Camera v2.1
Raspberry pi camera case/enclosure
by VGer

I have a V1 camera in mine. Not sure if the dimensions are the same on the V2?

This is great, thanks! Question though: I can't get the camera "mount.stl" to fit into the "Axis_change_connector_v3.stl"..? Looks like they are different sizes? Everything else fits together perfectly.

I'm sorry, I thought I replied to this but I don't see it...so just in case: My bad, I accidentally uploaded the original file...not the one I tweaked to add to my re-mix. I fixed it and deleted the incorrect file.