Fang Replacement Fan shroud for stock Tevo Tornado hot end.
The shroud has two mounting points, one of them is an original mounting point and the other one attaches to one of the threaded holes in the stock heat sink.
I've uploaded two versions, one that supports the bl-touch mount and one that does not.
It uses two 40mm radial fans that can be installed with 4 M3x12 screws each or other self-tapping screws that fit the mounting holes.
For the bl-touch version, you will and additional M3x8 screw for the mounting point where the bl-touch and the fan shroud overlap.
- I printed at 0.3mm layer with 15% infill and rectilinear supports with overhang threshold of 30 degrees.
Evolution of this "fang": https://www.thingiverse.com/thing:2773536
Ruiraptor's review and testing: https://www.youtube.com/watch?v=hoHz5LHyFUo