Table, desk or bed corner protector for children
This corner protector was designed to be printed in flexible TPE or TPU material to protector your children to harm themselves on sharp & hard table, bed or desk corners.
Should be attached to the corner of your table or desk with a piece of small adhesive tape.
Model was printed in red TPE material with 2 shells and 20% infill to make it more flexible and relatively soft.
Should be printed upside down so no supports are needed.
Model was designed in OpenSCAD.
Model was printed in red TPE material with 2 shells and 20% infill to keep it as flexible as possible.
When printed upside down no supports are needed (very hard to remove with TPE).
Use a wide brim to keep it attached to the printbed.