My "Anti Z Wobble" for Tronxy X5S.
- four 608ZZ bearing
- eight M3 screw (35mm)
- four M4 screw
- four 15x1mm washer (internal hole: 4 or 5 mm)
- two "T8 collar" to not put the weight of the bed on the motors
Optional: another collar can also be installed under the bearing in the lower support, but it is not necessary, the one above is sufficient.
The system works very well if all the bars are well straight and perfectly aligned with the frame.
The "up_guide.stl" allows to have a perfect distance between the bars and the central bearing, for the lower motor support you can use the acrylic one supplied with the printer.
If you want to offer me a coffee: https://paypal.me/pools/campaign/109337381886602477
Try and enjoy!
My slicing settings:
- layer 0.2mm
- three wall 0.4mm
- infill "full honeycomb" 80%
I printed everything in ABS, but also in PLA or PETG it can be fine.