This Creality CR-10 foot design uses the foam packaging material that was included with the CR-10. The feet replace the existing rubber bumpers, and use the original screws.
This made my printer WAY quieter by isolating it from the desk. I didn't expect much improvement in noise, but it made a massive difference.
Simply replace the rubber foot with this part, and insert the piece of foam (after cutting the foam to length).
The foam I used from the packaging had the following dimensions:
- Length: 300mm
- Width: 44mm
- Depth: 32mm
The foam is cut into 4 pieces, each about 50mm in length.
*Note: This design uses the original foot plate - only remove the rubber foot!