Yoda Vase

by yay Jul 30, 2012
Download All Files

Thing Apps Enabled

Please Login to Comment

Worked great! First print I scaled down slightly because of the project. Used 93%. Second print scaled up slightly110% also on second print out model 2mm below deck to get more drain holes open.

Tried 3 times and fail over and over...apparently the 3 holes are not holes and are someting that makes the whole printing to be "in the air".
I¿ll try to reduce the bottom by using the Feature "Cut Off Bottom" on the Cura 14.1 and see if that works

i have tried to print this twice and both times at about 60% done it messes up .

Remiving all the unnecessary artifacts for this print is a must... whatever these pillars/holes are for, and the dude in the center... it is a mess. Please clean up the file!

The holes doesnt Need. And One of them damaged the Body in Front. Over the left eye there is a hole during printing. But it is a very nice model. The figure does Nobody Need because printing Time get higher.

this model has some funky stuff going on at the bottom that would screw this print unless you offset the whole thing down a few millimeters. Could you post one without the dude and the bottom fixed? It would be fun to print it otherwise.

Hi how many layers and how did you
come up with such a cooooool idea?

how much infill did you use? has anyone tried printing without support and i also need to know how many perimeters for the shell (the yoda I tried broke like an egg as I removed it from the bed).

ok i think that was all i could ask ;)

why is there a man in his head

I was wondering the same thing. He must be the captain of the ship...

There's some cactus varieties that would look totally freaky in that thing. Not sure I would plant herbs I was planning to eat in an ABS print.


Is that a Chia-Yoda!?

Oh that is just so wrong!!