This case allows for easier viewing of the screen and controls as well as housing the control card allowing easy access to the SD card slot.
It used all M3 hardware... The cover is printed in 2 parts and snaps together, add crazy glue (or acetone for abs) to make permanent.
mounts 1 or 2 - 30mm fans I had left over that came with E3D hot ends.
angled back side allows built plate to lower fully.
I printed this with both an Anet A8 and the TronXY X5S
material: I used both PLA+ and ABS
printed with no supports except what I built into the model
After printing you will need to cut out the openings for the screen and knob. it should be only 1 layer thick at the seem and cut easily with an exact-o knife.
it helps to take an M3 screw and pre-thread all the mounting holes.