Tiny Whoov Lite- Low Profile Inductrix Hovercraft

by mambamax Feb 1, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

can I use the tinywoop original boar or I need thos with betaflight?

Works great :D
How are your runtimes ?
I´m using 1s hv with 255mah and only getting around a minute using a
custom betaflight.hex from rafls rc micro hovercraft
changed motor 1 and 4 and you have throttle on aux 3 and use a poti to hover
Other throttle as usal on the left for motor 3 and 4 at the back
Yaw on the right stick

RC Micro Hovercraft
by rafl

I'm pretty new to 3d printing and would like to try and print this. Wondering if you print it standing up or laying down in the slicer? Any support problems while printing? Thanks for any advice!

laying down with supports everywhere

Thank You. Awesome work!!!

Which motor goes to which position. I've looked at the pictures but i can't quite work it out.

Trying to figure this out as well...

nice model
so how does the bottem and top part connect ?
snaps snugly ? or glued ?

snaps together perfectly

Hey, it should be a snap fit! There's zero tolerance between the two pieces but since everything is relatively thin and malleable, it should snap over nicely. Mine did on the first try anyway!