If you can't print this, please consider ordering it through my 3DHub at:
This is a martian 2 HD box camera (Gopro, runcam 3, and I think the foxeer box is similar size too...) The first design the tolerances to keep the camera inside were not enough, and it was a little lose, but fit well. I have increased the top and bottom lips and the side, and reversed my original internal chamfer to be an external chamfer to help get the camera in, but increase retention.
I have added ziptie slots for added strength to hold it to your frame as well as the ability to move it between frames, and potentially only screw in 2 of the screws, and zip tie it down. This design is VERY light, but still provides good protection for the camera glass. There is a 20 degree and 35 degree version. I would highly recommend printing right side up for best layer strength for the screws.
Print it with supports.
If you are going to ORDER the part from someone, please consider ordering it from my 3D hub at the link below:
Find all my designs with #8BitFPV