This is a holder for Oneplus 5 and 5T with original case. It fits the original Oneplus charging cable and can be mounted directly to Brodit's tilt-swivel mount.
The fit is very snug with 5T+case but also a slighly narrower Oneplus 5 fits well and doesn't fall off.
The holder itself is a remix of gjlobb's design with a few modifications to dimensions and design to fit better with the clip and plate assembly.
With the clip and the plate you can install the holder to Ford Mondeo MK4 (and probably several other cars, too) without any permanent marks on the dashboard. It is assembled using 4 screws.
Everything were printed with PLA. I printed the clip with rafts and supports and 100 % infill. The plate and the holder were printed with 50 % infill without supports or rafts to make sure everything is sturdy.
The clip is printed with supports, rafts and 100 % infill.
The plate and the holder with 50 % infill without rafts or supports.