This is a PCB holder for Benchtop Power PCB you can get from ebay.
I just wanted something to hold PCB in place but still allow cables to be used for motherboards. It also tilts the ATX PSU upwards like a bench supply.
The design slides onto a 143mm X 86mm PSU side.
Requires 4 x M3 screws L=10mm and nuts.
Recommend insulation tape under PCB to prevent shorting of terminals.
Design is combination of openscad and DXF extrusion so please modify to suit. Files are uploaded for modifications. There are two DXF files. The one for openscad has all the unnecessary layers removed.
Note: My Part warped on printing (see photos) but did not effect purpose.
Part has to be flipped upside down to print from openscad output
Print time on Tevo Tornado was 4hrs.
Some Re-work for PCB Fix holes. I tapped mine.
Design started with an outline created in Librecad. All construction ideas created here.
Layer 0 is then exported to openscad and extruded and finalised in openscad.