This version 3 X Carriage fits a FLSUN Cube and is lighter and easier to maintain than the original.
- Clip-on LM8UU Bearings
- Clamping Style holder for Clone e3d V6 hot end (factory for my version of FLSUN)
- A 12mm Sensor holder
- A 15x50mm Blower Duct with wide outlet
- Lightest Carriage I have used, still plenty strong
This design does move the X-Axis Endstop above the intended contact point. You will need to Glue a stop trigger (included) onto the post for the endstop to contact.
You may want to use soluble supports as the ducting is thin and the supports inside are hard to remove. Carriage is strongest if printed with current orientation.
If soluble supports is not an option please use caution removing the supports ( I Found Zigzag was easiest to remove)