Update 25Nov2018 - addition for MiniUSB HDMI board cover in STEP and STL (NB: not prototype tested)
This is a 3D printed framing kit for a DIY Retina LCD Display.
All components of this print is sized for a 200x200mm^2 print bed, with no need for any support material, please refer to photo for correct print orientation, especially for the pivot piece!
Suitable for printing at 0.2mm layer height, 100% infill for all prints, total print time <10 hours
Bill of material
A iPad service replacement retina display LCD panel (~£25 or strip out an old iPad3)
A Mini DisplayPort Board (~£25) to drive the panel (Please note compatible part number!)
- Some fasterners
3.1. 28 x M2.5, 6mm (head included), countersunk screw (12 of which are for fasterning the facade for aesthetic reason, exclude if not required e.g. super/solvent gluing instead, note STL facade variant without screw holes)
3.2. 1 x m3, 18mm, bolt screw, for pivoting arm
Last but not least...
The assembly video!