I have been working for a long time on this one, its my one made Stompa on 28 mm scale.
Its between 30-40 cm high depending on its details chimney etc.. Its also have a small fortress on the back for about 10 orks to fit. There are 2 turret one fits a ork and a other can fit a goblin. Also the can fit a ork. In the under part of the body is a square space where a ork can be placed with turret. I did no have the time to pain it yet but it will be fun.
The body is made from 4 parts, there is also a big ork/glyph face to glue on it.
The feet are glued under the body. If this give any problem to balance there is base that can be glue between the feet an the body. There for you can lower the printing details on the body so it ca be print faster.
The arms consist of 3 parts each:
Gun, armforgun and arm pole to place in the body for the gun arm
Chainsaw, armforchainsaw and a arm pole
There are a different shoulder pad of each arm, the one for the gun can fit a ork.
For decoration you can place some small turrets under the holes, in the holes you can place ork heads.
For the head is there a plate between body and head, a head, a jaw and glyphe for the head.
For the big watch post can you chose to put a ork on it or a door (there is turret door file)
This one needs watch post part 1 and 2 + 3 holders. There is place to put a small turret on it. There also 2 files to make a big turret for the watch post.
A deco the border with the file: glyphessmall. I used about 7 glyphes.
Then is there file for holding the chimney's. I used 5 chimney's.
The file: holdersfordecoandminiturret is used to put the glyphes on it as deco and a mini turret for a goblin.
For the "fortress" I used the different platform files and metal plates fles. I used ladder files and add on ladders. (I also made from the holders for the big turrets and some chain a movable rope ladder but this not needed) I used the turret holder files to stud the platforms.
Let you imagination work.
I know this is a big project to build but very fun and its very impressive when build.
My direction are not that well, i know ;)
Just ask if you need any help or if there are any problems and I will help you.
Happy printing and building
The parts are created in 3d software, no copyrighted product had been scanned or copied.
Some parts needs support and some of the them needs a lot of infill depends on the part and the printer you using. If you do not know for sure just ask and i will be happy to help.