This is my very first remix and my first Thing in general.
I edited the original rails to fit larger size bearing, 608 that I had lying around.
As I am a complete noob, this not a masterpiece, and it's not even entirely complete yet, but it does work. But if you can wait a couple of days and get the 625 required for the original thing, I recommend you do that. However if you are impatient and only have 608, then feel free to try it out.
- Cylinders should probably be just tiny bit higher, maybe 0.5mm.
- Base of cylinders should be just a tiny bit higher (in relation to cylinders, i.e. more narrow passage of tray)
- Reduce cyllinder diameter also by a tiny bit to make bearings fit without sanding (97% should do, for my printer at least)
Any comments are most welcome!
I recommend to print lying 45 degrees to the side.
Support is only needed to keep it stable, but feel free to do as you are confident.
Also for me, when scaled to 97.5%, less sanding was required to fit parts (also depends on slicer and printer, I suppose).