IMPROVE YOUR MONOPRICE SELECT MINIS Z ACTION WITH Z-Pro!
Do you want carefully fitted prints sized just right for your IIIP Minis Bed Plate?
Do you want rigid added security and faster 3D action?
Do you want tool storage cameras lights lazors and precision ground rails on your unit?
3)-MEASURE YOUR STUFF:
-Find depth of 8mm holes in parts 5 and save to add to later measurement of distance between opposing faces of part 5 and 7 to give you length to cut shaft.
4)-DRILL NICE HOLES IN YOUR PILOTS, AND CUT YOUR SHAFT:
-Using cut off wheel on grinder Cut one shaft to found length less one sixteenth.
-Drill out all pilot holes for your selection of set screws. Tap holes if necessary.
5-ASSEMBLE YOUR AMAZING Z-Pro! by LEGACY 77-17:
A) -Assemble parts 1 2 and 3.
-Slide them into 4 sizing the assembly to the hole locations
on the side of the machine.
-Screw in place. (may need to use longer similar threaded same diameter screws).
B)-Push two of the 8mm x 300 mm shafts into your Z-pro Tool Holder.
-Remove the two screws on the top back of your printer to facilitate mounting the tool.
holder dual shaft assembly with the hole locations.
-Position and screw Tool holder shaft assembly into place using longer screws if
C)-Slide [dual lm88 camera arm index bracket] onto Z-Pro Tool Holder Shaft assembly
if you choose.
D)-Slide part seven long end facing to the back dovetail down.
-Press LM8UU bearing into part [6 X-SECURE].
-Slide bearing assembly onto sized shaft (77-77 Embossment facing forward).
-With LM8UU/Part 6 assembly still on shaft Press / Crazy Glue shaft into part five and
seven with their long ends facing out opposite each other.
-Slide assembly into Part 3 and 8.
E)-Complete custom options.
G)-Using Z control run x gantry to top and find sweet spot for part 8.
-Using Z control run x gantry to bottom and find sweet spot for part 5.
G)-Tighten down all set screws.
H) Hook Up your Camera to USB and Light To 12V Power Supply.
I) Test your new Rig!
More from 3D Printer Parts
Save to Dropbox
If you’re logged into Dropbox, you can save directly to Dropbox.
Show Some Love
Say thanks by giving 77-17 a tip and help them continue to share amazing Things with
the Thingiverse community.
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.