This is a holder for the lansky sharpening system, to hold your honing hones in place.
It fits 6 rods, which is more than enough.
The remix uses millimeter as a measurement unit. It uses little less plastic as the original.
I also reduced the height of the holders a bit.
The lansky system is really great for sharpening your knifes to a razor blade-like thing!
There are mainly two different types of systems:
The korund system:
And the diamond set:
I have both of them, they are really great!
Nozzle: 245°C ( eSun PETG http://amzn.to/2GrlK1n)
Print time: approx. 5,5h on a CR-10 (60mm/sec)
I used the following tape on my CR-10:
This stuff is really great, no extra glue needed, 100% sticky to the printed parts, which come off really easily, even without destroying the tape.
Another very hot tip is to use kapton tape! Here you get the glossy finish and perfect adhesion like with the blue tape! Look at this:
200mm Kapton tape: http://amzn.to/2nPggqi
(Amazon Affiliate Links)