Loading
liston156

Aomway Battery Adapter Shell

by liston156 Feb 22, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

I don't know what method you used to connect your cable, but I removed the pins from the connector, had to drill the hole a little wider, push the pins through the hole then reconnect them to the connector.

A better design would be to move the round hole next to the edge, then extend the two edges up, so that the cable can be pushed into it rather than having to disassemble the cable.

I found the cover to be too tight, so had the file two sides down slightly, but only a little. I see you have an A6, well this was on a A8.

I think I'd angle the edge of the belt clip up at the end, just to make it easier to slip on.

Thanks for the model, saved me making designing one :-)

Comments deleted.

Thx for this case! - It printed well rotated by 270 around x. I then put some of the supportstructure in the back where the cable connects, so there is no pushback when you plug in the balancer. Overall great!

Thanks, glad you like it