Please consider leaving a tip or donating via paypal on my website: http://ferociousdesigns.co.uk/ if you like this design! All support is very much appreciated!
A modular E3D carriage that works with both the standard v6 block and the Volcano block!
Works with clone and original E3D hot end - E3D V6 / clone hot end - Xcsource E3D v6 clone
- Height adjustable blower fan
- Height adjustable bltouch mount
- Mounts on SC8UU or equivalent bearing blocks
- Uses stock Anet A8 style belt holders
- Uses stock Anet A8 fan ducts, tested with Mistral 2.1a and Semicircular ducts
- Built in cable tie point
I printed in PLA with 25% cubic infill and 4 walls using 0.4mm nozzle. The parts came out very nicely as you can see in the picture ;)
#define X_MIN_POS -26
#define Y_MIN_POS -12
#define X_PROBE_OFFSET_FROM_EXTRUDER 38 // X offset: -left +right [of the nozzle]
#define Y_PROBE_OFFSET_FROM_EXTRUDER 0 // Y offset: -front +behind [the nozzle]
#define Z_PROBE_OFFSET_FROM_EXTRUDER -1.33 // Genuine bltouch at top of mount