I really like my the SuckIt Dust Boot, but my Vacuum hose had a long attachment on the end which made the whole system of adapters quite tall and it seemed like it was putting a lot of stress on the Plexiglas base. I designed this adapter to shorten the whole thing from three adapters down to one for use with a 1.5 inch OD vacuum hose.
Print with hose end down so that it will not require supports under the flat end that mates with the SuckIt Dust Boot. I found that it stuck to the bed quite well (heated bed with Painters tape) so no extra platform adhesion was required.
My printer left a few artifacts that made the fit a little tight, so I gave it a light sanding and a few swipes of candle wax to make inserting and removing it a bit smoother.