Iconic Sega Dreamcast Case for Raspberry Pi B+ / 2 / 3
Fits with a 30mm x 30mm x 10mm Cooling Fan (Refer to GPIO Pins for Power Source)
Cooling Fan : 4 Screws + 4 Nuts
Raspberry Pi : 4 Screws
Case : 2 Screws
You must use a Raft + Supports to print the Top part (cannot be printed without supports) / You must use a Raft to print the Bottom Part. If you don't use rafts (or a heatbed), the deformations (warping) will be visible when you assemble the case.
All the little parts are decorative and must be glued on the case.
Do not hesitate to enlarge the screw holes with the head of a little screwdriver if they are too tight.
If your power plug does not fit well in the cut, I advise you to lightly file the plastic.