This is an ironing board hook designed to interface with an off-centered T bar ironing board.
The end result is simple, yet stylish, and can blend in most decor.
If printed vertically (in the same orientation as it would be mounted on the wall), this model should not require supports but may require a raft or a skirt/brim.
Unlike some of my other prints, this one went very smoothly. I designed three versions of this ironing board hook and only had to print one. I measured the T bar dimensions and the diameter of the screws that I intended to use to secure the hook to the wall. I basically
modelled a box and a T bar. I subtracted the T bar from the box and refined the design to include screw holes and to enhance the resulting look.