Hi, this is my config.txt file that I use in my tronxy x5s printer. Is first configuration and you can see how it works in this video review of mks sbase board https://youtu.be/GuHpoGUpxUg

Attention, in this version .. in manual movements the endstops not works, negative movements are permits. I'll add to this thing the next updates .. enjoy ;)

Instruction

Copy config.txt on a sdcard and insert into sbase mainboard and power on.

Web interface ip: 192.168.1.19

I suggest to upgrade the firmware to the lasted version https://github.com/Smoothieware/Smoothieware/tree/edge/FirmwareBin

Set microstepping jumper to 32 microsteps, right corner near E2 driver.

Smoothieware doesn´t support dual-z configuration. You will need an adaptor to connect your z-motors in series. Here I explain two ways to do it https://www.thingiverse.com/thing:2538913

--
Photo of printing and other things on youtube in Community-Tab, my new instagram ;)
https://www.youtube.com/user/SgaboLab/community

Blogger with some diy guide http://www.sgabolab.com/
Pinshape Shop https://pinshape.com/users/130632-sgabolab

If you think to buy from Gearbest and want support me, use my affiliate link, thanks https://www.gearbest.com/?lkid=14695439