Loading
Hey! This thing is still a Work in Progress. Files, instructions, and other stuff might change!
pipa666

E3D cyclops and chimera dualextruder FLSUN Prusa i3 (2017)

by pipa666 Mar 11, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

There is my Firmware with config with Chimera settings.

Dobrý deň,
Už dlhšiu dobu hľadám firmware na tlačiareň flsun s dvoma extrudermi , ale neúspešne . Skúšal som nahrať do tlačiarne firmware ktorý bol na SD karte ale nefungoval . Potom som si pozeral návody ako upraviť firmware ale bez úspechu .Prestal ísť lcd displej a nešlo ovládať tlačiaren. Preto sa chcem opýtať či by ste mi mohli poslať firmware ktorý vy používate z dvoma extrudermi ? Predom ďakujem za odpoveď . PS: hladám Chimeru nie cyclops .

Zkus můj, ale mám tam nastaven autolevel a LCD 4x64 znaků. Pokud ho nemáš musíš si upravit oblast nastavení Z koncáku a LCD.
Vše je dobře popsáno v konfigu, jak nastavit, ale taky jsem ze začátku laboroval.

Mám tiež lcd 4x64 a autolevel , takže by to malo ísť . Ďakujem , vyskúšam

printed this except the fang and it works great

do you have the stl for the fang as need some cooling for my parts printed
thanks

Comments deleted.

can you add the fan mount please?

Comments deleted.

Hello :)

I printed almost all parts, but just one question. How do I connect mount to carriage ? There is no hole for screw :/
I just see the hex nut opening from bottom of carriage, but there is just low depth opening from top where screws should go,
can you please give me any hint how to do it ?

Thank you :)

Holes are in the carriage see to attached picture. Have to remove support pins from the hex holes.

So I need to drill them out ?:)

I send you a private message.

wanted to ask on your anti backlash nuts. I bought some 8mm size with a 2mm pitch but it does not fit our threads.

can you recall where did you get your backlash nuts. According to the flsun ours has a 1.25mm pitch

Comments deleted.

Why is the fan shroud completely solid inside?

Do you mean the supports or do you see fill in the tubes?

When I sliced mine it looks like it made a solid layer in the tube.

I print it out amazing design but is just missing the part for the rear wheel. Can you add it please?

I am sorry. I it added now.

ohh nice thank you very much for this design. Will show it to you when completed. Im printing it on my FLSUN i3 with PETG with 60% infill. I know is a lot, but I didnt want this important part to break

Comments deleted.

thanks for the help. Your designs looks good.

Saw you are using anti backlash nuts. is there any benefit from using them?

thanks

They have better accuracy and you do not have any Z-lift movement.

HI,

i am looking at your design and it looks like what i need.

Is the design printable as thingiverse mentions it is still work in progress

Yes it works, see to photos. I will create a video how it work.

Comments deleted.

What material did u used?

I has used the PLA. I has thought too does that not hold it but we will see it after burn test. Today I print 40 min on single nozzle and cooler is not have over 30°C degree.
I have PET-G or PAJET160 in storage, i do not like ABS it have very bad smell during print.