A toothbrush holder for oral-b. Fits on the charger. Can be marked with the colored rings.
-Openscad file added. You can modifiy the openscad file to match the holder to the calibration of your printer. You can also create a small pin (a miniumum holder for a single brush) to check the fitting before you print the complete holder.
- increased the number of faces to get smoother print
- added a variant which should fit more loose to the toothbrush as well as to the charger (_loose.)
Heads break easily if the infill settings are not matching the design. Check the upmost layer in your slicer below the heads before printing to ensure enough structures printed as a base for the heads. Change infill geometry or infill percentage in case of improvement needed.