Loading
Hey! This thing is still a Work in Progress. Files, instructions, and other stuff might change!
ortwin

Hubelino Marble Run Extended Parts

by ortwin Mar 11, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

Wow,

Thanks for all of your work. This is very exciting!
I periodically check for new parts for the DUPLO marble run.

Can't wait to print.

What were your print settings for the different parts??????

Thanks again

I always print at 0.2 mm layer height, no special settings were used. All parts are printed as they are in the model. Only exception is the windmill rotor which I printed on it's side so it works with minimal support and the axis comes out well. The slope elements also need support. Everything else should print well without support, even the small loops. (I have printed size 0.5 and 1.) Would be very difficult to get the support material out if you print with model on model support. I have not tested the bigger loops, yet. They might need model on model support or they might still work fine without, not sure. Also depends on your printer probably.

I am happy if other people print my stuff! :) Have you also tried the sound block? What kind and size of marbles do you use? I might try to make a variant of the marble pump for smaller marbles at some point if there is interest in it.

I am using 1 inch glass marbles that I made using flameworking techniques. (I am a glass artist). I am just now printing my first loop. I will let you know how it turns out and upload a picture of my MAKE.