Like many others I decided to utilize a glass/mirror bed for the MonoPrice Mini Delta. The mirror I purchased though was a 5 inch (127mm) mirror from a hobby store. The other clips on here were mainly focused on the 120mm glass beds. This clip was designed with a 5 inch (127mm) glass/mirror bed in mind. I also took into account some other clip modifications that have become popular among the Mini Delta owners, and tried to accommodate for the bed clips lifting up during the auto bed leveling process. The bed clips tolerances to the mirror are pretty tight so make sure the bed level switches are not getting stuck.
NOTE: One issue I noticed is if you use the G29 P5 command for auto bed leveling the nozzle might hit the edge of the clip based on where the P5 command taps down.
I have included the Fusion360 file, in case anyone would like to make modifications.
To account for different diameter hole sizes in the delta frame where the previous clips where and to account for possible different filament cooling shrinkage, I have added multiple STL files with differing diameter posts. The diameter sizes change in .05 mm increments. You will want the post to be as snug as possible to avoid the clip lifting when the auto bed level sequence is running.
I have included a V2 for all of the files. I made the bed overhang slightly smaller so it will no longer interfere with the G29 P5 command. I always got the best results using the G29 P5 command so I wanted to be able to use that command with my glass plate as well.
Printed with MakerGeeks Green Glass PETG.
This is designed so you do not need a pin like the original bed clips, you may need to lightly sand the post that goes into the Mini Delta bed where the previous clips where. However you do want it as snug as possible to avoid the auto bed leveling from pushing on the bed and causing the clips to raise up.