If You enjoyed this project and You want to say "Thank You" please consider supporting me by sending a tip on thingiverse or my PayPal here.
Simple Anycubic I3 Mega BLTouch Mount. You can adjust the height by using washers. Put it as far from the hotend radiator as You can. You will need four M3 screws.
Check my I3 Mega ULTIMATE upgrade guide! There is a lot of knowledge which may help You get the best 3D printing results. You will find it here: http://bit.ly/2OVbu5Z
BLTouch which I'm using: http://bit.ly/2p8kWYe
(This is affiliate link.)
X probe Offset -0.7
Y probe Offset -23.7
Use PETG or ABS. There is a lot of heat close to the mount, so PLA will not handle it.