A small comb that can be hung to a keychain and is very practical for combing small strands in any circumstance. I designed it to be able to undo and redo my braids while sitting in my sofa, but it's so small you could take it anywhere.
- new v3 version, with a better grip. The teeth tend to warp, don't know why.
- new comb meant to pin down a strand of hair, some kind of hairpin. Could be modified to carry some kind of aesthetic design (flowers, smileys, skulls, and what not...).
Prints very quickly due to its small size. You might print one in a matter of minutes, should it break. Beware of over-adhesion because it's a small flat object.
Print at slow speeds to reduce stringing on the teeth.
Infill is marked N/A because there should be no infill, so set whatever value you want.
Reports indicate it could be printed out of TPU, with interesting results.
I needed to clean up the strings between the teeth by running a knife there. Otherwise comes out ready for use.
If some teeth are warped it's possible to correct them using a gas lighter and a blade to push them back in place.