Decided to make a set of templates and tokens for Gaslands, I like these better than the etched versions since I find them easier to pick up because of the raised sides. There are both the right and left hand turn versions (yes I know you can flip them, but I was having fun…). For those of you that have a large bed on your printer there is also a Double template, I found this easier to use than the Medium/Long pair for ranged attacks. Lastly thought the gear shift was a good way of keeping track of turns.
The dropped item tags (Oil Slick, Caltrop, etc.) fit inside both small and large templates. I’ve printed everything and have not had any problems. I figured I would share as a way to give back to the maker community and to promote the game, I’ve had a lot of fun playing it, hopefully you will too.
Added Barriers: 3/19/18
Jersey Barrier is a 1/64th scale version of the typical concrete ones commonly found.
High Wall version adds 24" scale inches to height.
Added Bases: 4/6/18
Added bases for vehicles, these I just attach with a bit of removable mounting putty (stuff used to hang pictures on the wall) each are 2mm thick. I know the recommended sizes are different, these I have found to actually fit better to the vehicles I use.
20mmx30mm, 20mmx45mm Bikes
30mmx70mm Buggies, Bikes with side cars
35mmx80mm Cars, Jeep, Performance cars
Category above or below (Pickup Truck/Van/Tractor)
40mmx85mm Monster Truck
These were created entirely in AutoCAD and exported to .STL directly, they are based on the templates available from the Gaslands.com site which were used for the measurements.