This Modifcation is for;
In order to make removal of "Special Support" easy, the support design was changed.
The part itself is the same.
The affected STL Files are as follows;
- HPC-Rotor901ws (Original: HPC-Rotor201ws.stl)
- IPC-Rotor901ws (Original: IPC-Rotor101ws.stl)
Printer setting (Recommendation) (1.75mm PLA, 0.4mm Nozzle):
- infill: 100%, Layer Height: 0.2mm, No support, No raft
- Take care to remove the Special Support for damaging of the blade.
- Finish blade edges and surfaces as required.
I hope your work to be much improved.