This is a dash board for the Gaslands Game. More information about the game can be located here. https://gaslands.com/. The facebook group for Gaslands can be located here. https://www.facebook.com/groups/gaslands/ This was designed in Fusion 360.
If you like my designs and would like to buy me a coffee. You can click here. https://www.ko-fi.com/W7W3AYQN
Update 3/21/2018 Uploaded a split version of the top layer and bottom layer. each will need to be glued together. I tried to offset the seams so that they were not directly over each other. This was my first time splitting a file so if there are any issues please let me know.
Update 2 3/21/2018 Uploaded a split version of the Activate Token so that it can be printed flat and then glued together.
Update 3 3/21/2018 Uploaded a new version of the top layer with the Triangle around the Exclamation point for the Hazards. Also uploaded a new Version of the Top Layer split B file with the same update.
The two middle sections hold cards that are 42.5 mm X 76.5 mm you can create your own and laminate them or you can use the ones in Mal Hildreth's dashboard image that he posted on the gaslands facebook group. Those are the ones that I cut out to use. Also if you buy the 8mm cubes they range from 7.5 mm to 8 mm and should work fine. If you print the 8 mm cube I have listed mine printed out from between 8.2 mm and 8.4 mm which make for a tight fit so you might want to scale down and test for best fit. The text on the shifter is a little small to print properly so a Shifter without text has also been uploaded. The shifter is printed with supports and at 100% infill so that it can be drilled and a Neodymium Magnet can be added. Spaces on the underside of the bottom layer are for the corresponding magnet to keep the shifter in place. Please make sure you have the correct orientation on the magnets before gluing. The holes in the 4 corners are made for 3M 13 mm bolts and nuts.