Stand for a handheld safety razor of the type which you have to screw together after inserting a blade.
I designed this for my Merkur travel shaver, which looks like this: http://amzn.to/2Fbs2VT
This is my second iteration of the design (you can see the initial version here). While the first version was more elaborate, I found it a bit cumbersome in daily use. It seemed to me that a flat design would be more ergonomical, since I could put down and pick up the razor components horizontally rather than at an angle.
If you find this part useful, please consider a Designer Tip – this helps me to keep the filament flowing :)
I printed this in PETG, but it should work just as well in PLA.
You'll need to print 2 copies of Holder 1, and one copy each of Holder 2 and Holder 3.
Apply a bit of superglue to the outer ends of each holder and place them into the recesses on the base plate (see photo).