This is an attachment for mounting a Raspberry Pi Camera to the Snapmaker if you're running OctoPrint.
The arm swings from the front to 90 degrees to the right side of the printer bed. There are notches in the base in 15 degree increments.
The Pi Camera case and bracket are remixed from this mount https://www.thingiverse.com/thing:2265949.
Everything is snap fit, except for mounting the base to the printer and mounting the arm to the base. Details in Print Settings below.
You will need
- 4 x m4x8mm bolts to attach the base to the Snapmaker.
- 1 x m4x20mm bolt and nut to secure the swing arm to the base.
Note: Use supports for the PiCam arms.